How to Fix HP LaserJet Printer Fuser Error 50.2

Home/ Blog / How to Fix HP LaserJet Printer Fuser Error 50.2

How to Fix HP LaserJet Printer Fuser Error 50.2

HP Laser Printer may suffer from one of the common errors named as Fuser Error 50.2. In this blog, you will find many reasons that will be responsible for this issue to take place and various resolution methods combined with the set-up of HP laser printer. It will be so painful if your printer gets stopped suddenly while taking some important pages print. But, there is also one other method to fix it, i.e., calling HP Printer helpline Number.

How To Reset HP Laser Printer For Removing Fuser Error 50.2?

Method -1 Turn OFF & ON Once Printer Gets Heat-Up and Clean It

This error normally occurs because of heat generated inside the HP Laserjet Printer. First, turn on the power switch and second, turn it off. If the printer restarts, its temperature level will be normal, and it will not have any heat build-up issue inside it.

One way to recover this error due to heat generation inside the printer is just to switch off and switch on the power mode button. Once you switch off the printer, check the damage happening inside it because of heat build-up issues. If any extra paper is stuck to it or clogged ink, it is recommended to remove both without delay. This way, you will eliminate fuser error 50.2 and prepare the printer to run efficiently.

Method - 2 Make Sure Power Source is OK

The heat generation problem may arise at your power source. It is recommended that while operating your printer, keep an eye on the power source too to avoid fuser error 50.2 unnecessarily.

The plugs inserted in the power source should be similar to machine plugs to transmit high volume of electricity supply to the printer. The broken or loose power cable may be responsible for the heat-up issue and this way fuser 50.2 error. Make sure that a good quality power cable is used in a printer to take the power supply from the power source.

Method – 3 Measure the Temperature of Printer’s Location

Make sure that the printer should never be located in an extremely cool environment. You must ensure that if the printer location is changed, it should be given time to adjust with the changed location environment. It means the printer should be given time to warm-up according to the location environment.

Method – 4 Replace Fuser With A New One

Check the impact of the fuse in your printer, take out the fuser assembly, make sure that everything is running smoothly, and reset it. If all above actions are unable to fix your printer's error, then replace the fuse with a new one.

The above-recommended methods can troubleshoot fuser error 50.2 in your HP laser printer. If these steps are found difficult for you, it is the best way to connect with HP Printer Contact Number. You will get the instant solutions to eradicate this fuser error by connecting with technical specialists. The helpdesk service is available 24/7 hours to assist you in troubleshooting complex level issues.